[TenTec] Paragon 585

[MadScientist]

The same is true with the Omni 5 and 6.

Gary



> On Feb 2, 2018, at 6:09 PM, Bwana Bob <wb2vuf at verizon.net> wrote:
> 
> According to my Original Paragon manual, the meter lamps are 6 V.  There is a voltage regulator type 7805 on the  Low Level Amplifier/Noise Blanker board.  See section 6-18 on page 6-69: "Regulated 6 Volts is supplied to the meter lamps through connector O."  I presume that Ten Tec used regulated voltage for the lamps to prevent them from flickering during keying (like the 12 V lamps on my Corsair do.
> 
> The venerable #47, rated at 3,000 hours,  would be the lamp of choice.  However, the #755 is also 6V, draws the same current, but is rated at 20,000 hours!
> 
> 73,
> 
> Bob WB2VUF
> 
> 
> On 2/2/2018 5:04 PM, w8au at sssnet.com wrote:
>> Any bayonet base lamp rated at 12 - 14 volts.  Type 52 would do.
>> 
>> w8au
>> 
>> 
>> At 03:51 PM 2/2/2018, you wrote:
>>> I have a Paragon and need to replace the display/meter lights.  The ones in my radio do not have any markings on them.  Anyone know what the bulb is?  The manual/schematic do not show them!!  I plan to replace them with LED lights but need to know what is supposed to be in the radio first. Thank you -- Paul Ramey WG0G _______________________________________________ TenTec mailing list TenTec at contesting.com http://lists.contesting.com/mailman/listinfo/tentec </x-flowed>
>> 
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>> 
> 
> 
> ---
> This email has been checked for viruses by Avast antivirus software.
> https://www.avast.com/antivirus
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec