[TenTec] Omni VI display

[Stan Gammons]

I've tried that and it didn't help.  The connector between the boards 
next to the S-meter seems to be the one that's causing trouble.  Guess I 
could replace the connector or hard wire the boards together.

73

Stan
KM4HQE


On 02/25/2018 12:30 PM, Ken Brown wrote:
> Try reflowing the solder on pcb to connector pins. Maybe one of them is
> cold solder joint.
>
> On Sat, Feb 24, 2018 at 6:23 PM, Stan Gammons <s_gammons at charter.net> wrote:
>
>> Hi Everyone,
>>
>> I have an Omni VI that likes to throw fits now and then and not display
>> some of the segments on the display.  Seems like every time I deoxit the
>> pins and or resolder connections it works for awhile then it the same ole
>> same ole.  Ideas on a permanent fix for this problem?   I thought about
>> hard wiring the driver board and display board together.  That would make
>> it a pain to take them out if ever needed to though.
>>
>> 73
>>
>> Stan
>> KM4HQE
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec