[TenTec] Omni V upgrade to V.9

[Martin Sole]

I did my Omni V a couple of years ago. Very nice upgrade I think. For 
the labelling I did two things.

First I dismantled the front panel and swapped around the band buttons 
so they are in the right order then I printed labels in Word for the 3 
special functions, ENTER, SHIFT, CLEAR. I made these labels the same 
size as the band buttons with text I could read and pasted them above 
the 10m band buttons. That was a few years ago and they still look good 
and work well. I have a picture but I guess I can't post that here. It 
wasn't difficult, think I had about 2 or 3 try's to get the finish I wanted.

Martin HS0ZED



On 26/01/2018 21:42, MadScientist wrote:
> In the near future, I hope to be able to direct print things like this. I probably will not get to this project until late February but bookmark thet option.
>
> Gary
>
> W0DVN
>
>> On Jan 26, 2018, at 7:50 AM, Joe Radio <S9plus at hotmail.com> wrote:
>>
>> Since Carl has the chips, again, I am going to install one in my Omni V.
>>
>> I am wondering if anyone has the labels that came with the chips, back in the day?  How about a word doc or .pdf with the labels?
>>
>> A generous ham sent me a word doc, a few years ago, with home made labels that looked great.  Meanwhile, Carl ran out of chips and my old computer bit the dust, so the labels were lost.
>>
>> Anyone?  Thanks  Joe  WS9E
>>
>> Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 10
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec