[TenTec] PC Board Connectors

[Patrick]

Molex probably has a similar line but after not finding a product that 
exactly matched what I had in my Corsair II, I decided to take another 
run at the archives with a couple of different search terms. I finally 
found this posting from 2004:

Sent: Tuesday, August 24, 2004 2:41 PM
To: tentec at contesting.com
Subject: Re: [TenTec] Ten Tec "molex" connectors

Michael, Dana A wrote:

 > The  small white connectors used in the Ten-Tec Corsairs, Argosys, 
Deltas,
 > Omni-V and Omni-IV are AMP MTA .100 (AMP is now a Tyco Electronics
company)
 > available from Digikey and Mouser and other suppliers.
 >
 > The large white 4 pin and 2 pin power connector is also AMP but from the
 > Universal MATE-N-LOK series. (not Molex as some have miss stated).

I found the AMP ones at Mouser and they match exactly what I have in my 
radio. Thanks Bob for the reply and all the other emails suggesting 
different manufacturers. I had a couple guessing AMP but couldn't figure 
out the model number. I decided to repost the message from 2004 above in 
case anyone else goes looking for them in the archives.

Thanks !!!
Patrick
K4PNR


On 7/4/2018 8:30 PM, Bob McGraw K4TAX wrote:
> These are typically MOLEX brand connectors of the IDC type.  I suggest 
> you download the MOLEX catalog  and you can order as you need by model 
> number from either Digi-Key or Mouser.   Both have a good selection in 
> stock at reasonable prices.
> 
> 73
> 
> Bob, K4TAX
> 
> 
> On 7/4/2018 6:05 PM, Patrick wrote:
>> I apologize if this has been asked before as it certainly seems like 
>> it should have been. I've been all through the archives, the wiki, and 
>> even Google but cannot find an answer.
>>
>> Where can I get the different connectors that Ten Tec used in a lot of 
>> their older equipment, namely the Corsair II ?  These are the little 
>> clear connectors that the factory put numbers on to be plugged into 
>> their corresponding numbered sockets on the boards.
>>
>> Thanks !!!
>> Patrick
>> K4PNR