[TenTec] Omni V

Ken Brown kenradiobrown at gmail.com
Sat Jun 16 15:10:48 EDT 2018


What you really want to know is whether the receiver is performing
properly. I wouldn't mess with the S meter adjustments until I had a better
confidence that the gain from the RF input to the place the S meter
indicates the level is up to par. To really know you need to use
instruments. A signal generator with calibrated amplitude and something to
measure  IF power level where the S meter monitors it.

With minimal equipment you could make a comparison of the two radios. With
a fixed level CW input signal, even of unknown level, you could compare the
audio level across the high and low terminals of the volume potentiometer
to see if the two radios have similar overall gain. You could use an
oscilloscope or an AC voltmeter (DMM in AC millivolt range) to measure the
audio level there That would give you a clue as to whether the radio with
the low S meter reading has lack of gain.

If the gain between the RF input and the S meter is lower than it should
be, you want to fix that first, then adjust the S meter.

There are various standards for what S9 should be. 50uV for S9 is common.

DE N6KB


DE N6KB

On Sat, Jun 16, 2018 at 8:19 AM, n4uu73 <n4uu73 at gmail.com> wrote:

> Amplitude is down.
> Martin n4uu
>
>
> Sent from my Verizon, Samsung Galaxy smartphone
> -------- Original message --------From: Frank Kirschner <
> frank.kirschner at gmail.com> Date: 6/16/18  10:16 AM  (GMT-05:00) To:
> Discussion of Ten-Tec Equipment <tentec at contesting.com> Subject: Re:
> [TenTec] Omni V
> Martin,
>
> Does it sound lower in amplitude, or is it just the meter indication? I
> bought a used Omni V that worked fine, except the S-meter had somehow
> become misadjusted. A few moments adjusting the pots and everything was in
> order.
>
> 73,
> Frank
> KF6E
>
> On Sat, Jun 16, 2018 at 7:01 AM, Martin Pelt <n4uu73 at gmail.com> wrote:
>
> > I have an omni V that receive on all bands is about 4 s units lower than
> my
> > other omni V. Switch for antenna is in proper position. Any ideas before
> I
> > try to track someone down to repair.
> >
> > 73 Martin N4UU
> >
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>


More information about the TenTec mailing list