[TenTec] N1MM use?

[Ted Bryant W4NZ]

Mike,
According to their website, N1MM+ does not support the Paragon. 

For the others, look here:
<
https://n1mmwp.hamdocs.com/manual-supported/supported-radios/#general-tentec
-information>

73, Ted W4NZ

-----Original Message-----
From: TenTec [mailto:tentec-bounces at contesting.com] On Behalf Of Mike Golini
Sent: Tuesday, August 20, 2019 2:16 PM
To: tentec at contesting.com
Subject: [TenTec] N1MM use?

Has anyone used N1MM with their Paragon or Omni V, VI, or VI+?

I  have tried it on my Paragon II, but I get a cyclical noise over the
audio (not present when I transmit) using RS232 from my laptop to the radio.

Currently using as a Icom 735 in the N1MM setup (as suggested from the
Operator's Manual).  I did try using it as a Omin 6, which did not change
anything.

Just wondering if others have had this problem.  Not a show stopper, but
annoying.

73
Mike, K1SLT
-- 

mgolini at gmail.com
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec