[TenTec] Size of Ten-Tec grounding bolt

Byron Cordes byroncordes at icloud.com
Sun Aug 2 11:48:27 EDT 2020

Are they not all ready bonded together with coax shield?
Might make some ground loops by adding straps.
 Not your question think I would go with 1/4 holes and use washers with a little antiox stuff on connections. 
   Lightning and AC grounding should be your goal.
Remember more than one ground rod on AC or Antenna ground rod  should be bonded together with a wire running outside of house.  
73s Byron AC9PA 
Sent from my iPad

On Aug 2, 2020, at 8:35 AM, Winston <jones_winston at bellsouth.net> wrote:

I’m planning on buying some tinned copper grounding straps to tie together the ground lugs on my equipment.
I have an Omni VII, Jupiter, 229 tuner. They all seem to have the same size grounding bolt, but nowhere in the manuals can I find the size.
What size lug should be on the braids’ ends? 1/4” or 3/8” or something else?
73, Winston K4CWQ

Sent from my iPhone
TenTec mailing list
TenTec at contesting.com

More information about the TenTec mailing list