[TenTec] Jupiter problem

J.D. MacAulay, WQ8U jmac6235 at yahoo.com
Mon Feb 20 19:38:30 EST 2023


I have a Ten Tec Model 538 Jupiter and a Model 963 power supply I bought new in2001.  I am running Firmware Version1.28. It is not connected to an amplifier. 

 I was in a CW QSO,not using the internal keyer,  when thetransmitter turned on continuously.  Thekey had no effect.  I pulled the key plug – no change. The mike was not connected.

I switched modes.  CW,FM, and AM – transmits continuously.  USBand LSB switches to transmit (“P” = 0);  no RF output. This is consistent on all bands.

I did a RESET several times. It showed a RESET and received WWV.  When I went to the CW mode it showed the same continuous transmit problem.  Behavior did not change after RESET.

Suggestions would be welcomed.

73

Mac

WQ8U

Hillsborough, NC






More information about the TenTec mailing list