[TenTec] OMNI V

[ROLAND HOWELL]

Hi Robert
 From HIFI SSB here in the UK, he doesn't have another, a few other bits 
but not the push button pcb or the logic board.
regards
Snowy G0HZE

------ Original Message ------
From: "Dry Martini Holding Company" <qrp at kg4kgl.net>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Friday, 3 Nov, 23 At 16:08
Subject: Re: [TenTec] OMNI V
Who did you get the board from? I would like another PLC board for my 
Omni V.
Robert
KG4KGL

Sent from my iPhone
On Nov 3, 2023, at 09:01, ROLAND HOWELL via TenTec 
<tentec at contesting.com> wrote:

Hi All
An update on the Omni v, i was lucky enough to get a 81457 pcb from a 
'parted' out radio, that cured the no audio problem, also found a 
trapped wire on the PA section, terminal 1, the white wire, pos volts to 
the relay i believe, cut, soldered and heat shrunk it, sorted.
BUT i still have the button problem, now gravitating towards the 
ULN5818A serial interface, wondering if the shorted wire has corrupted 
something on the logic board.
Unless you can advise otherwise!
Cheers and beers
Snowy
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec 
<http://lists.contesting.com/mailman/listinfo/tentec>

_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec 
<http://lists.contesting.com/mailman/listinfo/tentec>