[TenTec] Issue with Centurion

Ted Schurter tedschurter at mac.com
Tue Oct 24 12:31:40 EDT 2023


All mentioned tests were done using a 50 ohm dummy load. SWR was 1:1.

Thanks  
On Oct 24, 2023, at 11:25 AM, Mike Cumbo <mcumbo at triad.rr.com> wrote:

> Is that to an antenna? What SWR? Have you tried loading a dummy load?
> 
> Mike Cumbo, ND4S
> 
> Sent from Mail for Windows
> 
> From: Ted Schurter via TenTec
> Sent: Monday, October 23, 2023 4:45 PM
> To: TenTec at contesting.com
> Cc: Ted Schurter
> Subject: [TenTec] Issue with Centurion
> 
> Hello All,
> 
> I have a Centurion amplifier that appears to have a problem delivering the specified output power.  When tuning up, everything seems to be ok except the amplifier can only deliver about 600 watts. The drive power at this time is about 25 watts. Further increase of the drive power will result in excessive plate current, with only a small increase in output power.
> 
> The plate voltage looks fine (3,000 volts no load). Both 3-500z tubes are new from RF Parts. 
> 
> Any thoughts or suggestions would be welcome.
> 
> Ted, WB2NVK  
> tedschurter at mac.com
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec



More information about the TenTec mailing list