[TenTec] Orion I problem

Michael mcelmer1 at netecin.net
Wed Oct 25 16:31:28 EDT 2023


Pete,

This appears to be a low voltage power distribuiton board problem not the blame RFI. I would suggest measure all voltages on the board +/- 5, VDC etc. If you are fortunate, here lies the problem; if the gods are not smiling upon you today, the problem could be the display and those, I believe, are no longer available. My Orion 1 had multiple LVPS distibution board failures in addition to 2 screen failures. The board due to my lack of mechanical aptitude had to sent out for repair: always the caps.

Mike
W8TRN

Sent from Mail for Windows

From: Reed Krenn
Sent: Wednesday, October 25, 2023 08:58
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Orion I problem

Are you transmitting into a dummy load, or an antenna? Ten Tec radios,
Orion included, are very susceptible to stray RF in the shack. If the
problem exists on an antenna, but not on a good 50 ohm dummy load, then RF
getting into the Orion control circuits is likely the culprit.

On Wed, Oct 25, 2023, 09:58 Pete Parisetti <peteparisetti at gmail.com> wrote:

> Good day list.
>
> Kindly have a look at the 30' video and notice what happens as I increase
> output power.
>
> https://www.youtube.com/watch?v=ta9jTzYq9Ps
>
> Power supply plenty strong, fuse OK, A9 board capacitors replaced.
>
> Thanks for any wisdom.
>
> 73 Pete MM0TWX
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec



More information about the TenTec mailing list