[TenTec] Orion Filter

Ted W4NZ w4nz at comcast.net
Fri May 30 08:09:28 EDT 2025


Make sure that those filters that aren't working are in the correct slot and that they have the thin insulator board underneath to prevent shorting out.

73, Ted W4NZ

-----Original Message-----
From: TenTec [mailto:tentec-bounces+w4nz=comcast.net at contesting.com] On Behalf Of Ken Brown
Sent: Thursday, May 29, 2025 10:58 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Orion Filter

You could move the filter to another position to see if the filter or the
switching to that filter slot is at fault If the Orion works like the Omni
VI there may be some bandpass shift or BFO adjustments necessary to make it
work.

On Thu, May 29, 2025, 11:35 AM Michael Marx <sndtubes at vacuumtubes.com>
wrote:

> I have a newly acquired Orion 1.   The filter board is loaded.   The
> optional filters were not enabled in the menu.  When Inenabled them, the
> radio would go nearly dead when the 500 Hz filter was switched in.   I
> tried another filter and got the same result.  Then I did a full reset.
> Problem still existed.
>
> There are diodes on the input and output of the filter.  There also
> appears to be a matching network.  I am suspecting the diodes.  Have any of
> you seen this type of failure or symptom.    What was the remedy?   I am
> guessing they are SMT components on the bottom of the board.   Is the
> FILTER BOARD hard to remove?
>
> TIA
> 73
> Mike WB0SND
>
>
>
>
> Michael Marx
> SND Tube Sales
> www.vacuumtubes.com
> 636-939-9190
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec




More information about the TenTec mailing list