TopBand: FT1000MP RX Input?

[K5NZ@aol.com]

>  Just a reminder to all using the FT1000D, the aux receive input is not
>well protected from excessive RF on its input. In an attempt to slightly
>improve my rx antenna situation I connected up a relatively low 160M-40M
>trap dipole to its input. On my small suburban lot the dipole is within 20'
>of the Inv L. Even though I was observing over 10W impinging upon it, prior
>to connecting it to the aux receive input,  I had assumed the radio would
>open the line when transmitting. It does not and it took less than one 
>character to smoke my 12db pad (and as a consequence my 18db selection
>also).

Does anyone know if the MP has this same problem or did they make a change on
the RX input to isolate during xmit?

Thanks  Mike k5nz

--
FAQ on WWW:               http://www.contesting.com/topband.html
Submissions:              topband@contesting.com
Administrative requests:  topband-REQUEST@contesting.com
Problems:                 owner-topband@contesting.com