Topband: Modeling DX Engineering 4 square rx array

[Ford Peterson]

> Is there an easy way to model this array in EZNEC? It
> would be nice to enter the feed system and be able to
> sweep a band of frequencies without having to change
> anything.
> 
> 73, Roger

Roger,

It's all about the tools you know.  

Imagine having a NEC2 GUI that used variables instead of measurements in space?  Complete with a geometric parser.  Name a length, an angle, and poof!  Instant wires in the right places.  It's got transmission lines, loads, unlimited wires, the works.  It will even build you a network to interface one impedance to another.  Even helps you wind your coils to boot.  Consider it an EZNEC on steroids.   www.nec2go.com

Just in case there are those out there that think I am using this reflector for selfish economic gain, hold the flames--I have no financial investment in or financial gain from Nec2go in any way-shape-or-form.  I've used it for years and can't imagine building antennas without it...

Ford-N0FP
ford at cmgate.com