Topband: .Pro III rx jack question-

[Bryon PAUL Veal n0ah]

Quick word on our K9AY 2 direction single loop- we had a ICE 196 voltage 
limiter so as not to blow out the rx jack on the Pro III but the ICE 196 
messed with the voltage as it goes out through the coax to control the 
relays- it was causing the B setting to go blank- so we took it out of line 
and the K9AY system is working fb- We have gone from S9 noise with the 
MA160V down to S 0-1 without the preamp on and s 2-4 with it on.  The front 
to back is awesome. We worked a C6 tonight while listening with the K9AY 
loop that the vertical never heard-  We are only using 100 watts and the 
apex of the K9AY  loop is 60 feet from the vertical- Using the standard 25 
foot mast set up with each loop pulled out 15 feet from the center and tied 
off at 5 feet before going back to the control box- If we blow the rx input 
on the pro III, we have a back up with the second rx jack- but I've heard 
the Pro III was improved to try and help one not blow out the rx jack as I 
used to do with my beverages and full power- Now without amps, I wonder if 
the 756 Pro III can take 100 watts into the rx jack with the vertical 
sitting where it is- ....guess we'll find out- any opinions on if the rig 
can take this or not?? Next option is to just run the 12 volts out to the 
control box but since the system is all set up for this, that could be 
asking for it- lessor of two evils- we'll try the 100 watts without the 196 
RF Limiter receive protection first-

73 all

Paul  N0AH
Anna W0ANT