Topband: 2 Parallel Beverages

[Greg - ZL3IX]

Hi Mike,

I have not tried to run two Bevs like that, but I have tried to run one 
close to a wire fence.  The best F/B I achieved was about 8 dB.  I would 
think that the two scenarios would be very similar.

73, Greg ZL3IX

On 2012-05-23 06:20 a.m., rfman45 wrote:
>
>
>
>   For various reasons I am considering two single, parallel but 180deg opposing direction beverages on the same supports rather than a single switchable bidirectional beverage.  The bevs would be separated by 12 to 18 inches or so. I've read that parallel bevs present performance degradation issues but has anyone had any experience with this type of setup versus the traditional bidirectional beverage? Thanks for reading this and for any thoughts you could offer.                                                                 Mike  W2LO   		 	   		
> _______________________________________________
> UR RST IS ... ... ..9 QSB QSB - hw? BK
>