Topband: TX/ RX Antenna Switching

[Buck wh7dx]

I need to figure out what's the best way to connect a beverage antenna for RX and my dipole for TX.

I have a TS-570 and I can use the Antenna 1 & 2 connection - but then I'd need to manually remember to switch when transmitting etc.  don't want to damage the beverage.

I have a Yaesu 987 that I can use as a dedicated Beverage RX but I'm concerned about overload from TX antenna nearby.

I'm using a 811H with about 400-600W showing up on my meter.

I use a DX 4 port switch for my 40,80,160 and HEX.   So run the Beverage to Antenna 2 or Yaesu?

A friend mentioned, that If I'm going to use a foot pedal.. perhaps wiring the PTT? to the Yaesu to switch it into TX with no MIC.. I haven't looked that up yet.  Basically, protecting RX by going into TX and no output??

I've seen this MFJ device which sounds like it might work?

http://www.mfjenterprises.com/Product.php?productid=MFJ-1708

There is also this DX Engineering device that might work?

http://www.dxengineering.com/parts/dxe-rtr-1


It seems to me that most are using a Beverage and TX so it must be very common and simple?

Any suggestions?

Thank you!

Bryan






[CONFIDENTIALITY AND PRIVACY NOTICE] Information transmitted by this email is proprietary to Mr. & Mrs. B and is intended for use only by the individual or entity to which it is addressed, or where ever the hell it ends up, and will almost certainly contain information that will offend a large portion of the population, which isn't our concern. If you are not the intended lucky recipient, or it appears that this mail has been forwarded to you without the proper authority of the Wizard of Email or Al Gore, you are notified that any thought, use, or consumption of this email is entirely your choice. In such case, Bon Appetit....    Note:  A $.02 Internet Tax was charged for receiving this email and all funds were given to some family somewhere in America or the U.N....  Have a nice day.