Topband: Pennant Transformer

[VO1HP]

I am in the process of building a pennant.

I'm stuck on the right way to wind the transformer.

I have Type 73 binocular cores but am not clear on how to do it.
I am feeding the loop with RG6 and my terminating resistor is 910 Ohm 2%.
The transformer will go at the point of the pennant and should be 12:1 
ratio ?

For 75 Ohm cable K6SE info sez - 2 turn primary and 7 turns secondary.

I see on W7IUV website he sez - wind the primary on first.
  --- so for  two turns I do this:
one turn is: -  up through one side and down through the other side.
another turn is - continue up one side and down through the other
--- that makes two turns...is that correct?

Winding 7 turns would follow same procedure winding the wire over the 
primary wire
and have the leads out the opposite end of the core from the primary?

I hope you can follow my primitive description.  Am I on the right track?

73 Frank VO1HP