Topband: Beverage transformer and testing

Stan Stockton wa5rtg at gmail.com
Fri Feb 2 11:20:14 EST 2018


Put a 600 ohm resistor or something close across the secondary leads where
the beverage would be connected and hook up an analyzer to the primary
wires and see what you read on your analyzer.  Check it from about 1.5 to 5
mhz and you should see a good SWR over that range and more.

73...Stan, ZF9CW

On Fri, Feb 2, 2018 at 10:33 AM, MR TREVOR DUNNE <ei2glb at eircom.net> wrote:

> Hi I know it's probably been covered here hundreds of times but I'm
> looking to make a matching Transformer for a 550ft beverage to 75 ohm coax,
>
> I have so bn73-202 cores
>
> Also how can I test it once it's built
>
> Thanks
> Trevor
> EI2GLB
> _________________
> Topband Reflector Archives - http://www.contesting.com/_topband
>


More information about the Topband mailing list