Topband: Computer noise

[Artek Manuals]

Could be coming from the power supply? Sometimes simple clip on chokes 
are not enough either. I have a similar problem here on 20M I have dual 
(Identical) monitors . One has an irritating but not debilitating  spur 
on 20 the other doesn't ..If I swap the monitors the spur follows the 
monitor. Have tried a handful of ferrites to no avail so it is likely 
"radiated" IMO  and not conducted.

Grumpy Dave
NR1DX

On 11/26/2019 6:41 AM, Rodman, David wrote:
> A few ideas might be helpful here.  I was at the station over the weekend and found a significant amount of noise coming from one of two computers in the station.  Significant noise S5 at 1820.  One computer runs the cluster and 2m connection.  That was clean.  The other handles most of the remote chores and has about 15 USB serial devices attached.  Everything was off, except a battery operated transceiver attached to the receive antenna feed, the modem for the cable and my router.  One can definitely see that operating the computer, closing windows or plugging in USB devices causes the modulation on the signal to change, this isolating the source to the computer alone and possible connections to peripherals (they were all turned off by the way).  I did have few chokes available but attaching them to the USB wires out of the computer to their various devices made no improvement.  I could get more specific but need to leave for my office now.  Any ideas might be helpful and appreciat
>   ed.
>
>
> ---
> David J Rodman MD
> Assistant Clinical Professor
> Department of Ophthalmology
> SUNY/Buffalo
>
> Office 716-857-8654
> _________________
> Searchable Archives: http://www.contesting.com/_topband - Topband Reflector

-- 
Dave
Manuals at ArtekManuals.com
www.ArtekManuals.com