Rotator fit

[k4sb@avana.net]

Had the same problem with my Tailtwister in 25. I cut one of the diagonals at the half way
point, pulled the out to where the beast would go in, and then pushed the diagonals back in
place. Cut a 6" piece of diagonal from a junk section ( NEVER throw anything away ) and
used large cable clamps to clamp it across the cut. Probably overkill, but little trouble.

73

Ed

-------------------------------------
Name: Ed Sleight
E-mail: k4sb@avana.net
Date: 1/12/97
Time: 1:03:46 PM
-------------------------------------


--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 K7LXC@contesting.com
Sponsored by Akorn Access, Inc & KM9P