[TowerTalk] "Pre-install" Your Rotator

[DavidHarper@tx.slr.com]

>       While you're testing rotators on the ground, I prefer to have
> them set
> to North as the final step. It simplifies the beam alignment when
> you're
> finishing the installation.
> 
At my previous QTH, there were no obvious landmarks for North
(treetops), so I always set the rotor to 30-degrees because I knew that
was the heading where a good sighting landmark did exist (aimed straight
down my roof-line).
73
Dave WD5N



--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com
Search:                   http://www.contesting.com/km9p/search