[TowerTalk] Hole Alignments

[Gerald Caouette]

James D. Bruce wrote:
> 
> What is the best way to mark and drill holes in a straight line along an
> alumimun tube? Also drilling thru to the other side of the tube straight? An
> example would be 2 holes along the axis of an element for a U-bolt. It seems
> that I never get it correst and end up enlarging the holes to get hardware
> to fit. Thanks,
> 

2 machinists V Blocks and a drill press
Level the drill press table and square to the drill shank.
Clamp the two v blocks to the drill press table so as a small rod 
ie 1/16 or smaller placed across the blocks is centered on the tip 
of the drill . remove small rod replace with tube and drill first hole
Place a rod in the first hole  use this and a level or plumb bob to 
align remaining holes if the tube is quite long you 
may wish to add a support stand fabricated from some small 
1X2 lumber..

hope this helps
73
de
ve6nap@oanet.com

--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm