[TowerTalk] inside/outside--CORRECTION I goofed

[K7GCO@aol.com]

<< In a message dated 7/6/00 6:30:03 AM Pacific Daylight Time, w3svj@juno.com 
 writes:
 
 << 
  Try the sporting goods store. They have an assortment of bore cleaning
  brushes for fire arms that should take you through 1/2 inch ID (45/50
  CAL?). Larger than that may require a trip to the military surplus
  depot, 105 155 MM etc. You might say that's where the "big guns" go for
  antenna maintenance products, then again you might not.
  
  73 de Nate, W3SVJ, in Pittsburgh where it's not so smokey anymore.
  _ >>
 
    As a shooter I liked you "big gun" analogy.  At stores that sells nuts 
and 
 bolts, they often have steel brushes of different diameters above 1/2 inch 
 that are ideal for cleaning the insides of aluminum tubing.  I've even made 
a 
 holder for the end of a 12' length of tubing for steel brushes to clean the 
 insides of tubing full length. 

CORRECTION !!

 With quads and 1 permanently soldered 
 joint/element you "DON'T" need all this hardware.  K7GCO
 
 

--
FAQ on WWW:               http://www.contesting.com/FAQ/towertalk
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com