[TowerTalk] Straightening Bent Aluminum Tube

[Bill Hawkins]

Fill the tubes with sand and slowly and gently straighten
the tubes. The sand will prevent kinking.
Bill W5EC

-----Original Message-----
From: Jeff Maass <jmaass@columbus.rr.com>
To: towertalk Mail List <towertalk@contesting.com>
Date: Wednesday, June 28, 2000 12:30 PM
Subject: [TowerTalk] Straightening Bent Aluminum Tube


>
>I have a used KT34XA to be installed, and the end of one of the 
>elements was bent in storage. The bend is in 1/2-inch and
>a 3/8-inch tubing, and the bend is gradual. No sign of kinking in 
>the tube.
>
>Is there a preferred procedure for straightening-out aluminum tubing,
>to minimize the possibility of weakening, kinking or breaking?
>
>Should I just replace these two sections of tubing?
>
>73,
>Jeff Maass       jmaass@columbus.rr.com     Located near Columbus Ohio
>         USPSA # L-1192       NROI/CRO    Amateur Radio K8ND
>    Maass' IPSC Resources Page:  http://home.columbus.rr.com/jmaass
>
>
>--
>FAQ on WWW:               http://www.contesting.com/FAQ/towertalk
>Submissions:              towertalk@contesting.com
>Administrative requests:  towertalk-REQUEST@contesting.com
>Problems:                 owner-towertalk@contesting.com
>
>


--
FAQ on WWW:               http://www.contesting.com/FAQ/towertalk
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com