[TowerTalk] Motor leads for CDR44?

[Mark S Graalman]

  The heavy gauge wires go to terminals 1&2 on
my Ham-M, i'm guessing it would be the same
on your unit.

Mark  WB8JKR


On Sat, 04 Nov 2000 07:39:59 -0500 Gerry Hull <windev@inetmarket.com>
writes:
> I have a CDR44 rotor which I am putting in a 
> tower about 175ft from shack.  I have plenty
> of wire, but most is 22 ga 6 conductor control
> cable. I also have a pair of #14 cable.  Can some
> one tell me which of the two of the 8 wires 
> are the motor?
> 
> 73,
> 
> -Gerry, W1VE/VE1RM
> 
> 
> 
> --
> FAQ on WWW:               http://www.contesting.com/FAQ/towertalk
> Submissions:              towertalk@contesting.com
> Administrative requests:  towertalk-REQUEST@contesting.com
> Problems:                 owner-towertalk@contesting.com
> 

________________________________________________________________
YOU'RE PAYING TOO MUCH FOR THE INTERNET!
Juno now offers FREE Internet Access!
Try it today - there's no risk!  For your FREE software, visit:
http://dl.www.juno.com/get/tagj.

--
FAQ on WWW:               http://www.contesting.com/FAQ/towertalk
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com