[TowerTalk] Florida Ham fights UV - uses tape???????????

Avila, Edward EAvila@caiso.com
Tue, 24 Oct 2000 11:39:05 -0700


Mark.......I agree, I too wrapped my C3E PVC with UV-resistant tape before
installation. Interestingly enough, Force 12 recommends UV-resistant paint,
but I was too lazy to go buy paint for this purpose.....anyway, so far so
good!

Regarding holding feedline to a tower, I learned the hard way to use metal
clamps which I wrap from the inside with tape to protect the coax sheath and
"gently" tighten them over the feedline.....tie wraps and tape just isn't up
this task........73/k6sdw

-----Original Message-----
From: Mark . [mailto:n1lo@hotmail.com]
Sent: Tuesday, October 24, 2000 11:26 AM
To: towertalk@contesting.com
Subject: RE: [TowerTalk] Florida Ham fights UV - uses tape???????????


Hi Jim,
I think UV resistant electrical tape makes an excellent sacrificial 
protection layer.
In a UV protection role, as opposed to a fastening role, such as holding 
feedlines onto tower or antenna hardware, I try to keep the following in 
mind:
- clean and degrease the part to be protected with rubbing alcohol
- tape with minimal tension
- stretch only to eliminate wrinkles
- overlap wraps by 1/2
- try not to get moisture or finger oils on the tape
- cut the ends cleanly with a sharp blade and minimal tension to eliminate 
flagging.

I think tape wrapping can be done quite neatly if you take just a little 
extra time.

When I assembled my C-3E antenna 14 months ago, I taped the grey PVC 
insulators using Scotch Super-88. After 14 months of exposure, they look 
great (just did an inspection) with no signs of flagging. I also 
spiral-wrapped my fiberglass 2m/440 vertical, and it is fine also.
  For the rectagular plastic enclosure on the match box of my 2m beam 
(Cushcraft 13B2), I cut the tape into strips and stuck it on with no 
tension, covering each side independently.

>From the ground, you can't even see the neat spiral lines.

For other plain PVC parts on my tower, I sprayed them with flat grey 
indoor-outdoor acrylic paint as a sacrificial layer to intercept the UV. 
This seems to be holding up well, too.

Good luck with your project!

--...MARK_N1LO...--
  Gloucester, VA
_________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.

Share information about yourself, create your own public profile at 
http://profiles.msn.com.


--
FAQ on WWW:               http://www.contesting.com/FAQ/towertalk
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com

--
FAQ on WWW:               http://www.contesting.com/FAQ/towertalk
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com