[TowerTalk] Yaesu G1000-DXA Rotor

[Rick Conners WA7ND]

I have recently ground tested/calibrated the above rotor per specs and have
now mounted it on the BASE of a MA-770 Tower.

Now I need to re-calibrate it to the real world...the rotor's true north is
about 30 degrees off of my antennas magnetic true north.

I know the easy way to do it is to pull the indicator arm and set it to my
antennas true north. However, this throws everything else out of
calibration, ex: the over-rotation indicator comes on in the wrong spot and
the preadjust is also thrown off.

Does anyone out there have a way to calibrate this system, short of
dropping the antenna and rotating IT to true north. Normally, I would slip
the tower inside of the mounting brackets but I have a bolt holding an
extension of the bottom of the tower so the rotor clamps can only be
tightened in one position.

Any help would be appreciated.

73,

Rick
WA7ND
wa7nd@arrl.net
ThunderPaws Ranch
Tumalo, Oregon, USA






--
FAQ on WWW:               http://www.contesting.com/FAQ/towertalk
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com