[TowerTalk] N7VM Tower Project Report 11/22/2001

Bill Ralston n7vm@lgcy.com
Thu, 22 Nov 2001 13:23:56 -0700


The permit has finally issued!  Went down Tuesday and picked it up ($170.64
fee). Although I have lots of #4 (1/2") rebar lying around, I didn't have
any #6 (3/4") as called out for the base. Of course, #6 is not readily found
at Home Depot either, but after a bit of asking around, was finally pointed
in the right direction.  $6.80 netted me four 4' lengths of the stuff from
the local rebar supplier. (Felt a little funny getting my 4 little pieces
while they were loading up a flatbed truck with tons of the stuff using the
big crane...).

A little further research to discover I was looking for a "hickey bender"
tool for bending the small stuff used in the cross braces and guy anchors.
$16 for that from a concrete forms and supply store.

Unfortunately, mother nature has decided it might be time to start winter
here in Utah, and we are supposed to get a series of storms over the next
few days. In fact it's raining/snowing now.  If the weather cooperates, I'll
rent a transit and we'll lay everything out Friday. Otherwise, it might be a
while, since I have some other obligations the next couple of weekends.
Sigh.


List Sponsored by AN Wireless:  AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 100 feet for under $1500!!  http://www.anwireless.com

-----
FAQ on WWW:               http://www.contesting.com/FAQ/towertalk
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com