[TowerTalk] Rohn TB55D Torque Bars and Torque Arm Lugs for the TA55

[Michael Rauh]

Hi TTer's,

Rohn says they no longer make TB55D torque bars for use with the GA55GD guy 
bracket.  Does anyone know have dimensions for these torque bars so I can 
make my own, or know where I can buy some.  Even approximate dimensions 
would be helpful to me - like, how long are they?  One foot, two feet, three 
feet?  I'm guessing two feet would be about right.

I could also use information and dimensions on the Torque Arm Lugs for the 
TA55 Channel Torque Arm.  The lugs are on the Rohn print, but I haven't been 
able to get any information from Rohn about them.  I imigine the lugs are 
needed if the torque arm assembly is mounted in the middle of the section.  
The lugs would provide a bearing surface for vertical downpull on the torque 
arm assembly.  Do they attach with u-bolts?

Beat Regards,

Mike Rauh, NV7X

Reply to mikerauh@ic.org


_________________________________________________________________
Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp


List Sponsored by AN Wireless:  AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 100 feet for under $1500!!  http://www.anwireless.com

-----
FAQ on WWW:               http://www.contesting.com/FAQ/towertalk
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com