[Towertalk] Guy Grip Question

[Rick Bullon]

Well Stan I have to disagree with you on this one.
First the grips are not made by Rohn so the info is just their suggestions. 
When I bought the big grips for my tower they came with black ty-wraps and 
the instructions said nothing about end caps just the ty-wraps. So I would 
say that Steve is correct on this point.
73
Rick
KC5AJX


>This is one of those times when LXC himself does not follow the "LXC Prime
>Directive".  I specfically remember reading in the Official Rohn Book that
>when you use guy grips, you MUST always use end sleeves (NOT tie wraps) 
>with
>them.  They don't say why but if you can install a guy grip with your hands
>and nothing more than a screw driver, then it stands to reason that you (or
>any kid or vandal) can remove one the same way.  If any guy grips are
>accessable from the ground, I would strongly recommend installing end
>sleeves to discourage, or at least slow down, a vandal or an irrate
>neighbor.  See page HA101 in your Rohn Book for installation procedure.
>
>Stan
>w7ni@easystreet.com


_________________________________________________________________
Send and receive Hotmail on your mobile device: http://mobile.msn.com