[Towertalk] T2X Problem

[FireBrick]

When you put it back together, did you make sure the indented part of the
bell housing sat over the pot's arm?
It's easy to misorient.

I always use the control to turn the rotor fully in one direction.
Make a scratch where the two housing join to indicate proper positioning.
After repairing or replacing the pot in the direction it was when opened,
you will have it oriented correctly for reassembly.


----- Original Message -----
From: "Nelson Moyer" <ku0a@mchsi.com>
To: <Towertalk@contesting.com>
Sent: Thursday, April 18, 2002 12:54 PM
Subject: [Towertalk] T2X Problem


> I lost the directional indication on my T2X, brought it down, and found
the
> wiper arm had worn down and dropped off of the rheostat windings. Being
> thrifty, I soldered a short piece of #8 wire to the end of the wiper arm,
> filed it down on top the clear the upper stop, and checked it with the
> controller. The directional indication works when I rotate the arm
manually,
> but the arm does not turn with the rotor motor on. Any suggestions on what
> do do next, besides send it out for repair?
>
> _______________________________________________
> Towertalk mailing list
> Towertalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>