[Towertalk] T2X Start cap at tower base?

N2TK n2tk@arrl.net
Wed, 14 Aug 2002 14:47:29 -0400


Ditto. Works fine doing it this way. Closer tot eh rotor the better for the
motor start cap. Plus you get to double up two wires. It's a win-win.
Tony
N2TK

-----Original Message-----
From: towertalk-admin@contesting.com
[mailto:towertalk-admin@contesting.com]On Behalf Of Mike Gilmer, N2MG
Sent: Wednesday, August 14, 2002 14:05
To: towertalk@contesting.com
Cc: k1uo@prexar.com
Subject: [Towertalk] T2X Start cap at tower base?

K1UO wrote:

<< I notice from the T2X schematic that the start cap is across pins 4
and 8 of the connectors.  If I cut the rotor cable about 5 ft up from
the base of the tower and put the start cap and weatherproof housing
there will I notice any difference in T2X start operation?
Has anyone already tried this?  I can leave the other start cap in the
control head and just insulate those particular leads out at the tower
base.>>

Closer is better - many folks split the difference (between mounting
right at the rotator - where it belongs - and leaving it in the control
box - where CDE put it) and mount the cap at the bottom of the tower
where it's accessible. Leave the start cap in the controller and just
disconnect the wires on 4 and 8.

Since you then have two "spare" wires from control box to tower base,
you can then double up the the heavy (brake/motor) wires on 1 and 2 for
some more benefit.

Mike N2MG



_______________________________________________
Self Supporting Towers, Wireless Weather Stations, see web site:
http://www.mscomputer.com
Call 888-333-9041 to place your order, mention you saw this ad and take an
additional 5 percent off
any weather station price.
_______________________________________________
Towertalk mailing list
Towertalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk