Fwd: [Towertalk] stripping enameled wire

Andrew Pfeiffer va3pl@cuic.ca
Tue, 17 Dec 2002 07:41:13 -0500


Try this:
Take an aspirin tablet. Lay the wire flat on aspirin tablet and then use 
hot soldering iron with a dab of solder on it then pull wire slowly out 
of between the aspirin and soldering iron. The enamel should be stripped 
and wire tinned. 
It might take fair amount of heat.
It smell badly while you do this so use well ventillated area.
The aspirine is acetylsalicylic acid so make sure the wire is cleaned 
after.
Andy - VA3PL

PS. It might not work on some kind of enamel.

-----Original Message-----
From: "N2TK" <tony.kaz@verizon.net>
To: "Towertalk \(E-mail\)" <towertalk@contesting.com>
Date: Tue, 17 Dec 2002 07:20:47 -0500
Subject: [Towertalk] stripping enameled wire

Is here anything out there that strips enameled wire for soldering easily
instead if scrapping it with a knife? Got to make up several transformers
with #28 wire. Want to se if there is an easier way to do this. There
used
to be some liquid you dipped it in, but that was many years ago.
Tnx
Tony
N2TK


_______________________________________________
AN Wireless Self Supporting Towers at discounted prices, 
See http://www.mscomputer.com 

Wireless Weather Stations now $349.95. Call Toll Free, 
888-333-9041 for additional information.
_______________________________________________
Towertalk mailing list
Towertalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk