[Towertalk] WX0B Six-Pack

[K3BU@aol.com]

In a message dated 6/19/02 4:22:23 AM Eastern Daylight Time, 
bob@cytanet.com.cy writes:

> 
>  My current arrangement has the relay springs adjusted to provide good 
wiping
>  on the N.O. contacts (I hope!) and I have 16.5V across activated coils to
>  overcome the spring tension.  There is the risk that after prolonged use I
>  may burn out a relay coil but I'll have to deal with that if and when.
>  

I saw somewhere (G3? or Rich Measures page?) circuit for power supply 
arrangement, where the relays get higher voltage "shock" when first turned 
on, then voltage drops to nominal for holding the relay closed. This would 
allow enough tension to wipe on NO and have enough pull to close the contacts 
for C and enough voltage to hold without danger of burning our the coils.
But.... that should not be needed with "normal" relays. (Could be bad batch 
of mislabeled relays?)
Assuming that the problem is not with dirty contacts.

Yuri