[Towertalk] andros 2 piece N connectors

[Rajiv Dewan, N2RD]

I really like these connectors.  Unlike regular N, these do not come 
apart.  The assembly of the inner part is much like assembling an UHF 
connector.

To measure, I just line up the coax with the connector, parallel with 
each other and remove the shield, dielectric from tip of the connector 
to a little above the hole for soldering the shield.  I then remove 
another 1/4 to 3/8 inch of jacket to expose the shield.

Hope this helps,
Rajiv, N2RD
On Saturday, October 5, 2002, at 12:01 AM, steve sala wrote:

>
> I bought several N male connectors from HRO to connect
> to my 9913F7 for my VHF/UHF beams which have N
> terminations.  The handbook shows a multi piece N
> connector only.  The Andros web site sucks, nothing on
> using their connectors.  Does someone have the cutting
> dimensions to this connector?  The connector says
> Andros and made in USA and the connector solders the
> center pin on its side and the braid sort of like a
> PL-259.  (This is an antenna topic because it is
> stopping me from installing the antennas.....hihi)
> Thanks, 73, Steve K7AWB Spokane
>
> __________________________________________________
> Do you Yahoo!?
> Faith Hill - Exclusive Performances, Videos & More
> http://faith.yahoo.com
> _______________________________________________
> AN Wireless Self Supporting Towers at discounted prices,
> See http://www.mscomputer.com
>
> Wireless Weather Stations now $349.95. Call Toll Free,
> 888-333-9041 for additional information.
> _______________________________________________
> Towertalk mailing list
> Towertalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>