[TowerTalk] Hardware Question
K3BU at aol.com
K3BU at aol.com
Wed Dec 31 10:23:27 EST 2003
In a message dated 12/31/03 1:07:55 AM Eastern Standard Time,
k4oj at tampabay.rr.com writes:
>>I have tried to moderate the amount of solder I apply at the tip
but even with a concerted effort I have too much solder a lot of the
times... <<
Let it cool off. Then heat just the tip with soldering iron and while it gets
soft, just wipe it with rag or paper towel. You will end up with rest inside
and remove just unwanted outside blob while maintaining plating.
Yuri, K3BU
More information about the TowerTalk
mailing list