[TowerTalk] Insulated Wire

[Roger Parsons]

I am building a wire array using insulated wire (copper clad steel + 
jacket). The insulation will change the velocity factor of the wire and 
therefore change the required lengths of the elements. EZNEC does not have 
an option to calculate the actual lengths required, and I am wondering if 
there is any way to do this? It will be very difficult (and expensive) to 
change the antenna once erected, and as the effect would be primarily on the 
array pattern rather than the feed SWR it would be hard to 'tweak'.

I have seen suggestions that wires should be 3% shorter or 5% shorter but 
then cut and try - that is a lot of difference!

Any suggestions would be gratefully received.

73 Roger
VE3ZI

_________________________________________________________________
Tired of spam? Get advanced junk mail protection with MSN 8.  
http://join.msn.com/?page=features/junkmail