[TowerTalk] Neighbors

N4CW at aol.com N4CW at aol.com
Wed Mar 26 20:29:00 EST 2003

Tom, N4TL, and I are separated by about the same distance as you and your 
neighbor. We're both contesters and DX'ers. We do have some differences, 
Tom prefers SSB where I prefer CW. That gives us some solace from interfering 
with each other. However, during contests we often vie for the same 
stations...that's unavoidable and we just tolerate the extra-loud signals for 
the short while.
First of all, address the fundamental component of the station, the 
What is key here is that first and foremost, you both have "clean" 
rigs...minimal phase noise and clicks. Once you've both taken care of those 
problems (filters won't cure problems on the same band, just the type of rig 
and mods to insure the cleanliness of the signals will do that), then you can 
address harmonics, often taken care of by bandpass filters or coaxial stubs. 
Good receivers are a requirement, not an option. There are lots of 
comparative analyses of receiver and transmitter performance (look at ARRL 
product reviews, and the in-depth reports available to members, on the ARRL 
web site.) Don't forget that extremely strong signals may cause non-linearity 
in your own receiver (as well as your neighbor's), which is why filters will 
minimize their effect when either of you is on another band.
Good beam antennas (e.g. at least three elements on a yagi) will afford some 
front-to-back attenuation, and, generally even more front-to-side. Quads and 
log-periodics can't make the same claims. Another thing about yagis, they are 
monobanders and thus provide some attenuation of harmonics (the more 
attenuation, the better, under neighborly considerations!). Tri-banders don't 
offer the band-to-band isolation because of their inherent nature (that's the 
"tri" part...).
I don't know enough about verticals to speak of it, but I suspect that "near 
field" signals as well as the omni-directional aspect of such an antenna (not 
an array!) would definitely be something to avoid.
Of course, use well-shielded coax (like "Bury-Flex", RG-214, or hardline) to 
keep the r.f. contained in the transmission line. Cheap coax usually has 
minimal braid allowing quite a bit of signal leakage (in and out).

Oh, and another thing: remember to use only as much power as you need to do 
the job. Tom and I can operate very very close (frequency-wise) using just 
our transceivers. It's when we kick on the "afterburners" that stresses our 
receivers!  And, speaking of amps, remember that phase noise and key clicks 
get amplified along with the desired signals, so it's better not to have 
those problems to start with.

Good luck, enjoy your hobby as well as your neighbor's,

Bert, N4CW

More information about the TowerTalk mailing list