[TowerTalk] or2800 m2 rotator into Rohn 25 tower

[Harold W4OW]

  An OR2800 M2 rotator can be squeezed in at the bottom of the top section
of Rohn 25 by removing the lowest horizontal brace from one side. This
leaves enough space to slide the rotator inside with a little effort. This
brace can be replaced with a piece of flat bar 1/4" X 1" held by "U bolts".
This will weaken the original strength perhaps so take this into
consideration. Also you will see that the mast clamp bolts will be a little
difficult to secure unless you have a universal socket on an extension.