[TowerTalk] Re: Bolts, ID??

[Robert Shohet]

Hi Mel,

The diameter of the head of both bolts is 9/16".

I can't tell you the thread pitch since I am not familiar with that
term.

I am very skeptical of these bolts sold to me as "Rohn Hardware",
but I wanted to inquire of those more knowledgeable than I.

Tnx & 73

Bob KQ2M

----- Original Message ----- 
From: <Bgsalesmel at cs.com>
To: <kq2m at earthlink.net>; <towertalk at contesting.com>
Sent: Sunday, August 15, 2004 11:31 PM
Subject: Bolts, ID??


> You didn't state the diameter nor thread pitch. That could be important.
> The "3-letter" identifier on the top, just being stamped there in ink,
makes
> me think these are common grade from Home Depot. This is how the clerk
looks
> up the value and uses a printed/book bar code to charge you at the check
out
> stand. I don't think I would use these on a tower leg.
>
> YMMV, 73
> Mel Frost
> KD7DCR
>