[TowerTalk] Yaesu G-1000SDX

[Paul Playford]

Does the control box growl at you when you are turning the rotator?  If so
check the rubber band that drives the dial indicator.  I used a drive belt
for a VCR to replace it.

de Paul, W8AEF

----- Original Message ----- 
From: "Manuel Larsson"Teknik forumet"" <manuel at limmared.nu>
To: <towertalk at contesting.com>
Sent: Tuesday, August 17, 2004 1:51 PM
Subject: [TowerTalk] Yaesu G-1000SDX


Hi



I am trying to trouble shoot a Yaesu G-1000SDX rotator.

 The rotor box gets no reading on the direction indicator. Can anyone tell
me which pins I should check to see if the variable resistor is working or
not?



Any common fail modes for this type of problem on this rotator?



I test it for about 1 week ago and the its work 100%

Manuel SM6TMR
manuel at limmared.nu