[TowerTalk] Pull rope in PVC

kb9yku kb9yku at comcast.net
Thu Dec 23 22:50:41 EST 2004


the miles of conduit i installed  and pulled wire into
i have found it better to remove the old  wire pull it back in with 
the  new wire
unless  you  use a new conduit
put 2  runs of conduit   in ware you need one now

2 in  conduit  mite help with a  small fill
like wire that would  fit in a 1/2 in. in the two inch
they make liners  to  help you add  more wire later  its 
used  in  underground ducks
its  polyethylene  i think  and you pull them all in at one time with a 
light pull  string  in it  to  pull  rape in with
kb9yku






  At 12:10 PM 12/23/2004, Mike wrote:
>Hello,
>
>Second what Mike state in his response.
>
>I've found, from hind sight as Mike said, the best method is to get as 
>many cables through the PVC with the initial "pull".  Also, remember to 
>attach a "traveller" to the front of the cables to allow the pull rope to 
>be retrieved through the pipe.  Keep the cables and the traveller line 
>going into the pipe as parallel as possible.  You want to keep the 
>traveller from wrapping around the cables.  Getting the traveller and the 
>cables to stay parallel with each other may be impossible, but try to 
>minimize the traveller line getting wraped around the cables.
>
>The large PVC pipe will make the next pull of cable(s) much easier even if 
>the traveller line does get wrapped around the initial set of cables.
>
>A four inch PVC pipe is run from the house to the base of the tower (~60 
>ft) at K4GMH.  Using the above technique three "pulls" were used to get 
>two FSJ-4 coax cables, and control cables made of out of 14 gauge NM for 
>the following:  two stack match pluses (six wires each),  two antenna 
>selection switches (four wires each), two rotators (six wires each); plus 
>the two, sixteen wire control cables for two, 4 element SteppIRs.  The 
>majority of the cables came through the pipe during the initial pull.  The 
>two other pulls were made without any problem.  By using a traveller line 
>the pull rope is still in place ready for the next inevitable cable(s) 
>that will go through the pipe.
>
>At 10:16 AM 12/22/04, Mike Bragassa wrote:
>>And to add, Roger:
>>
>>Secondly, expect the future pull-rope that you ran in the PVC  to snag or 
>>twist up on something in your PVC at a later date.
>>Might pay to run a cable or larger  rope? (Something less apt to snag.) 
>>Hind sight is always 20-20.
>>
>>Mike Bragassa, K5UO
>>
>>"Rule of thumb...
>>
>>Always use at least twice the size of conduit you think you need."
>>
>>Roger Halstead (K8RI, EN73 & ARRL Life Member)
>>
>>_______________________________________________
>>
>>See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless 
>>Weather Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with 
>>any questions and ask for Sherman, W2FLA.
>>
>>_______________________________________________
>>TowerTalk mailing list
>>TowerTalk at contesting.com
>>http://lists.contesting.com/mailman/listinfo/towertalk
>
>         73,
>         Mike, K4GMH
>
>_______________________________________________
>
>See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless 
>Weather Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with 
>any questions and ask for Sherman, W2FLA.
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk at contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk




More information about the TowerTalk mailing list