[TowerTalk] Technique for Putting Don Radials?

[David J Windisch]

BTDT except used 500' spools cuz I could carry them.  I small-split-bolted
the ends for a "continuous" run.  Stripped the insulation at the center and
big-split-bolted the radials together in 4 groups.

Next came 2 months of ignoring neighbors' stares and township notices, all
for not mowing the grass.

It's a one-ohm-ground at some frequency.

Works fine, fails safe, drains to the bilge.

73, Dave, N3HE


----- Original Message ----- 
From: "Eric Rosenberg" <wd3q at starpower.net>
To: <topband at contesting.com>; <towertalk at contesting.com>
Sent: Monday, June 21, 2004 5:40 PM
Subject: [TowerTalk] Technique for Putting Don Radials?


> At a recent PVRC meeting, an interesting method for laying down lots of
> radials for a vertical.  Instead of cutting each radial individually and
> attaching each piece to the vertical section, this technique involved
SNIP