[TowerTalk] Rotor plates

kb9cry at comcast.net kb9cry at comcast.net
Thu Nov 4 08:05:04 EST 2004


That's probably because rotator plates are not meant (by Rohn) to be used with TB-3 thrust bearings, just rotators.  The Rohn top plates are drilled for TB-3s but not rotators.  I'd say get out your drill and have at it.  Don't forget to spray some cold galvanizing on the inside of the holes as you'll have bare, unprotected metal there.  Phil  KB9CRY

> I stand corrected. Just looked at a spare one I have around and, sure 
> enough, no TB-3 holes! 
> 


More information about the TowerTalk mailing list