[TowerTalk] Why Did I Order These?

[Tower (K8RI)]

Mike Switzer wrote:

> Hi All
>
>
>
> I purchased some N connectors and unknowingly ordered crimp on 
> connectors.
> Before I send them back I would like some opinions.  I got TC-400-NM 
> Times
> Microwave Systems connectors.  It calls for a .429 HEX die crimper to be
> used for installing the connector.  Anyone have any experience with these
> connectors?  Anyone know where I can get a crimper at a reasonable price?
> Maybe I should purchase a crimper and use these . what do ya think?
>
>  
>
I picked up some 2 piece N connectors at a swap this summer.  They are 
silver plated brass and a tad less expensive than the regular N-connectors.
They are very easy to use and make a more solid connection than the 
regular N-connectors.

The center conductor is a permanent part of the insert which looks a lot 
like the back end of a PL-259.  Cut about a half inch of insulation, 
brade, and dielectric off, trim back another half inch of jacket, twist 
in place, solder the center connector (it has a tiny hole in which to 
apply solder), solder shield through the two holes, and screw together. 
It has a gasket inside for sealing.

No, they aren't near as fast as crimping, but for the cost of the tool 
and handles I could replace every connector in my system thrice over and 
I have a lot of connectors. Not nearly as many at Tom, but then again I 
only have one acre and two towers, not an antenna farm on top of a 
mountain. <:-))

>
>
> Ignorant in Goodrich, MI (EN82)
>
>  
>
Where's Goodrich?  The UP?

Roger (K8RI) in Midland

I gotta get my sig into this mail reader.