[TowerTalk] Rotor connector waterproofing?

Paul Ferguson Paul at PaulFerguson.us
Thu Aug 10 13:16:29 EDT 2006

I had a Ham IV rotor serviced by Norms and had them install a quick 
disconnect connector in place of the terminal strip. 

The short cable from the rotor to the male connector they installed 
has a black sealant around where the cable exits the connector. 

I have installed the female connector to my rotor cable and want to 
seal the space where the cable exits the connector. What type of 
sealant is best to use here? The connector is an Amps 9-pin of which 
8 are used. The female end is labelled 206708-1.

What have you found to be the best way to waterproof the mated 
connectors on the tower?


More information about the TowerTalk mailing list