[TowerTalk] Noise canceler hook-up

[George VE3YV]

For the FT1000MP family, you can hook the noise canceler to the 
auxiliary RX ANT port and let the rig do the T/R switching for you.  By 
selecting the primary (A/B) antenna, always used for TX, and either the 
primary antenna or the aux RX antenna, you can also switch the noise 
canceling unit out of line.  Details on the www.va3cr.net site.  Thanks 
to Bob, N6TV and Ron, W4LDE for the information.

73,  George VE3YV / K8HI
> ------------------------------
>
> Message: 4
> Date: Sat, 26 Aug 2006 09:27:47 -0400
> From: "WA3GIN in Alex. City, VA" <wa3gin at erols.com>
> Subject: Re: [TowerTalk] noise canceling
> To: "'Thomas Tow'" <ttow1 at charter.net>, <towertalk at contesting.com>
> Message-ID: <002a01c6c913$6f42acc0$6301a8c0 at TS480WA3GIN>
> Content-Type: text/plain;	charset="us-ascii"
>
> CAUTION:  The ANC-4 requires >50 watts to key the switch over relay.  If you
> are using a linear that requires less power or running QRP there is a high
> probability that you will fry the early front stages of the sense circuit.
> Timewave has a bulletin that will show you how to connect the ANC-4 to your
> PTT circuit of the transceiver (basically taking one lead to ground in xmit
> mode).
>
> You can also put two units in series and work on two difference noise
> sources.
>
> 73,
> dave
> wa3gin
>
>   
>