[TowerTalk] 160m inverted l

[Jerry Keller]

When I'm trimming wire antennas I don't start longer and cut off a little at 
a time.  It's too easy to cut too much off.  I start longer and roll up the 
wire on a dowel or even my finger until it's too short. If I roll it out a 
little at a time until it's too long, then I can go back a bit.  Works 
pretty good.

73, Jerry K3BZ

----- Original Message ----- 
From: <ersmar at comcast.net>
To: <towertalk at contesting.com>; <ny6dx at aim.com>
Sent: Friday, December 08, 2006 11:04 AM
Subject: Re: [TowerTalk] 160m inverted l


> John:
>
>     Start out with about 130 feet of wire and trim about six inches at a
> time until you get the min SWR where you want it in the band, usually 
> around
> 1830 kHz or so.  You should end up with something around 123 feet of 
> length
> but that depends on the usual antenna things like everything else that's
> around the antenna, etc.  .
>
> 73 de
> Gene Smar  AD3F
>
>
> ----- Original Message ----- 
> From: <ny6dx at aim.com>
> To: <towertalk at contesting.com>
> Sent: Friday, December 08, 2006 9:27 AM
> Subject: [TowerTalk] 160m inverted l
>
>
>> I am trying to figure the length of inverted l using #12 insulated wire. 
>> I
>> come up with 120 ft is this right?
>> ________________________________________________________________________
>> Check Out the new free AIM(R) Mail -- 2 GB of storage and 
>> industry-leading
>> spam and email virus protection.
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk at contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk