[TowerTalk] Cutting 3/16" EHS...

[bob finger]

I agree with Steve  Get yourself a smallish "angle grinder"  electric 
ones can be had for 30 bux or so.  If you have a good sized air 
compressor the air driven grinders are even better.

If you are only doing this a few times and you have no need for a 
grinder (don't know how people get along without them tho) then a thin 
cut off wheel for your skill saw will do the trick nicely.  73 bob de w9ge

K7LXC at aol.com wrote:

> 
>  
>
>    A better option is to use a 4.5" hand-grinder. I  couldn't do any tower 
>work without one. Get the thinnest cutting blades and  they'll cut thru EHS in 
>a couple of seconds. Obviously all safety precautions  should be used. 
> 
>    I used to use the 7" aggregate cutting blade on  my Skil saw but it was 
>pretty cumbersome. The little hand-grinder is the only  way to go!
> 
>Cheers,
>Steve      K7LXC
>TOWER TECH  
>
>
>
>
>
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk at contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
>
>
>
>  
>